Results 1 to 2 of 2
  1. #1
    news.new
    Guest
    Try this, especially you use T105 with S*l Hi-card (> pre-paid card, as
    Hi-card has longer wait between "calling" and "connecting" due to remaining
    $ value announcement)

    1. make a call to anyone
    2. During display of "calling" (ie while $ value announcemnet)
    3. adjust volume of speaker via side sliding switch
    4. press NO as decided no to call

    The phone will just display "calling" on screen and hung.
    The phone will accept incoming call.
    The phone will beep if sms come in but you cannot display the message.
    Except YES/NO/C key, no other key cannot be used. You can only power off by
    removing battery.

    After you remove the battery to reset the hung condition. Some critical
    setting is lost (eg, phone lock)

    Firmware is at latest R9D. There is no fix to this problem currently.

    This is a quick way to simulate hung problem. This phone currently can hung
    without good reason. But above method will make you phone hung almost
    everytime.





    See More: T100 or T105




  2. #2
    news.new
    Guest

    Re: T100 or T105

    This message was taken from one Sony Ericsson forum.

    "news.new" <[email protected]> wrote in message
    news:[email protected]...
    > Try this, especially you use T105 with S*l Hi-card (> pre-paid card, as
    > Hi-card has longer wait between "calling" and "connecting" due to

    remaining
    > $ value announcement)
    >
    > 1. make a call to anyone
    > 2. During display of "calling" (ie while $ value announcemnet)
    > 3. adjust volume of speaker via side sliding switch
    > 4. press NO as decided no to call
    >
    > The phone will just display "calling" on screen and hung.
    > The phone will accept incoming call.
    > The phone will beep if sms come in but you cannot display the message.
    > Except YES/NO/C key, no other key cannot be used. You can only power off

    by
    > removing battery.
    >
    > After you remove the battery to reset the hung condition. Some critical
    > setting is lost (eg, phone lock)
    >
    > Firmware is at latest R9D. There is no fix to this problem currently.
    >
    > This is a quick way to simulate hung problem. This phone currently can

    hung
    > without good reason. But above method will make you phone hung almost
    > everytime.
    >
    >






  • Similar Threads