Page 1 of 2 12 LastLast
Results 1 to 15 of 30
  1. #1
    JRW
    Guest
    This is not good. For the past several days my Sanyo 4900
    has been beeping as it looses and gets back a signal. Screen
    says Digital Roaming and sometimes Analog Roaming. I verified
    that its set for Sprint PCS only for the network choice.

    Today was the worst, couldn't make any calls at all without
    roaming. Considering that 90% of my calls are from working at
    home (I use the PCS-to-PCS and unlimited night and weekends
    extensively), I might start sounding like Justin if this
    isn't resolved.




    See More: Digital and analog roamin message




  2. #2
    larry
    Guest

    Re: Digital and analog roamin message


    Has to be a problem with the phone not the network.

    --
    Posted at SprintUsers.com - Your place for everything Sprint PCS
    Free wireless access @ www.SprintUsers.com/wap




  3. #3
    Steve Crow
    Guest

    Re: Digital and analog roamin message

    As crappy as Sprint's network can be, that really sounds more like a phone
    issue than anything else, especially if the phone is ignoring your "Sprint
    PCS Only" preference. That's not a problem I've seen in a 4900 before, but
    I have seen it on a couple other Sprint PCS phones.

    Most interesting one was an LG1010 that claimed to be analog roaming.

    ....quite a stunt for a phone that's digital-only.

    Steve


    On Sat, 25 Oct 2003, JRW wrote:

    > This is not good. For the past several days my Sanyo 4900
    > has been beeping as it looses and gets back a signal. Screen
    > says Digital Roaming and sometimes Analog Roaming. I verified
    > that its set for Sprint PCS only for the network choice.
    >
    > Today was the worst, couldn't make any calls at all without
    > roaming. Considering that 90% of my calls are from working at
    > home (I use the PCS-to-PCS and unlimited night and weekends
    > extensively), I might start sounding like Justin if this
    > isn't resolved.
    >
    >



    ----== Posted via Newsfeed.Com - Unlimited-Uncensored-Secure Usenet News==----
    http://www.newsfeed.com The #1 Newsgroup Service in the World! >100,000 Newsgroups
    ---= 19 East/West-Coast Specialized Servers - Total Privacy via Encryption =---



  4. #4
    JRW
    Guest

    Re: Digital and analog roamin message

    larry wrote:

    > Has to be a problem with the phone not the network.


    So i guess sticking it in the microwave wasn't a good idea.

    *JUST KIDDING*




  5. #5
    Bob Smith
    Guest

    Re: Digital and analog roamin message


    "JRW" <no_addy@no_.com> wrote in message
    news:[email protected]...
    > This is not good. For the past several days my Sanyo 4900
    > has been beeping as it looses and gets back a signal. Screen
    > says Digital Roaming and sometimes Analog Roaming. I verified
    > that its set for Sprint PCS only for the network choice.
    >
    > Today was the worst, couldn't make any calls at all without
    > roaming. Considering that 90% of my calls are from working at
    > home (I use the PCS-to-PCS and unlimited night and weekends
    > extensively), I might start sounding like Justin if this
    > isn't resolved.
    >


    As others have piped in, this sounds like a phone issue and not a system
    issue. You might want to take your phone into your local SPCS store and
    have it tested ...

    Bob





  6. #6
    JRW
    Guest

    Re: Digital and analog roamin message

    larry wrote:

    > Has to be a problem with the phone not the network.


    Well...It doesn't appear to be phone related. My spare phone
    that's not activated is doing same thing and two neighboors
    are experiencing the same problem now.

    I'm going out on a limb here, what if the cell coverage was
    realigned? But that wouldn't explain getting a digital roaming
    message, more likely an analog roaming message if I'm out
    of range of the tower. Keep in mind, I'm over four miles from
    the tower to begin with.

    Yeah...yeah...Time to call executive services. No need to bother
    calling CS, going to a store, or using common sense to fix what may
    be a simple problem. Again, JUST KIDDING!




  7. #7
    CAT0NHAT
    Guest

    Re: Digital and analog roamin message

    It may be a little problem, easily fixed at the store, or the phones might
    benefit from a new PRL which can be done over-the-air, or it could just be
    increased traffic has decreased the effective range of the tower(s), and an
    area that was well covered by Sprint is now at the feather edge fringe. Sounds
    all too much like Justin's situation to me.

    Good luck JRW, and report back.



  8. #8
    JRW
    Guest

    Re: Digital and analog roamin message

    CAT0NHAT wrote:

    > It may be a little problem, easily fixed at the store, or the phones might
    > benefit from a new PRL which can be done over-the-air


    Four different model phones all within a quarter mile radius, all
    started experiencing the same problem at the time? That doesn't
    sound liek a handset problem. If it was just one phone, then I would
    tend to agree with you.

    > increased traffic has decreased the effective range of the tower(s), and an
    > area that was well covered by Sprint is now at the feather edge fringe.


    This is what I'm thinking. For past three nights, its been impossible
    to use the phone right after 9:00. It might be the cell is loading up
    and the noise floor is increasing to the point where my signal is the
    weakest one.





  9. #9
    w.g.
    Guest

    Re: Digital and analog roamin message

    Somewhere around Sat, 25 Oct 2003 02:08:02 GMT, JRW was brave enough
    to write:

    >This is not good. For the past several days my Sanyo 4900
    >has been beeping as it looses and gets back a signal. Screen
    >says Digital Roaming and sometimes Analog Roaming. I verified
    >that its set for Sprint PCS only for the network choice.
    >


    Might be solar flares if it just started to happen. Take the battery
    out and reset to see if it is ok now. Here is an article about it
    http://www.cnn.com/2003/TECH/space/1...ast/index.html

    ----------------------------------------------------------------------------------
    42.7% of all statistics are made up on the spot.
    ----------------------------------------------------------------------------------
    tnpnr@mind+spring.com
    remove the +



  10. #10
    JRW
    Guest

    Re: Digital and analog roamin message

    w.g. wrote:

    > Might be solar flares if it just started to happen. Take the battery
    > out and reset to see if it is ok now.


    The problem I'm having is similar to when I work a data center
    which is very RF shielded. Sprint phones go into analog roaming
    mode.




  11. #11
    Bill
    Guest

    Re: Digital and analog roamin message

    If you have the phone in Sprint only, it cannot go into roaming unless the
    phone is not properly reading the PRL or the PRL is screwed up, and most
    unlikely would be someone is transmitting the same PN as sprint in that
    area. When it says Digital roam try to call CS and see whose you get.
    "JRW" <no_addy@no_.com> wrote in message
    news:C%[email protected]...
    > w.g. wrote:
    >
    > > Might be solar flares if it just started to happen. Take the battery
    > > out and reset to see if it is ok now.

    >
    > The problem I'm having is similar to when I work a data center
    > which is very RF shielded. Sprint phones go into analog roaming
    > mode.
    >






  12. #12
    JRW
    Guest

    Re: Digital and analog roamin message

    JRW wrote:
    > This is not good. For the past several days my Sanyo 4900
    > has been beeping as it looses and gets back a signal. Screen
    > says Digital Roaming and sometimes Analog Roaming. I verified
    > that its set for Sprint PCS only for the network choice.


    Took both of my phones into Sprint store. Both checked out
    all right and have most current software.

    Both phones are still jumping in and out of digital and analog
    roaming.

    Shows four bars, but that of course is misleading as it doesn't
    reflect the current noise floor as cell loading increases. It just
    shows I'm in range of the tower.




  13. #13
    CAT0NHAT
    Guest

    Re: Digital and analog roamin message

    > Took both of my phones into Sprint store. Both
    > checked out all right and have most current
    > software.


    > Both phones are still jumping in and out of digital
    > and analog roaming.


    Monday morning call the 817 Executive Services number and give them the choice.
    Either you get free roaming, or you get out of Early termination Fee. A phone
    must be "Fit for Purpose" if you are no longer covered by Sprint, the contract
    is null and void as Justin Green found out.

    If you get no satisfaction mail in your phone and one month's payment, with a
    copy of your letter to your states Attorney General, and certified to Sprint in
    Fort Worth.



  14. #14
    JRW
    Guest

    Re: Digital and analog roamin message

    CAT0NHAT wrote:

    > Monday morning call the 817 Executive Services number and give them the choice.


    I'm going to start watching it for a week and start calling CS everytime
    it happens. Once I can demonstrate there is indeed an issue, I'll have
    more leverage.







  15. #15
    larry
    Guest

    Re: Digital and analog roamin message


    I find it hard to believe that a phone set to Sprint PCS only mode could
    go into analog or digital roaming without it being a problem with the
    phone.

    --
    Posted at SprintUsers.com - Your place for everything Sprint PCS
    Free wireless access @ www.SprintUsers.com/wap




  • Similar Threads




  • Page 1 of 2 12 LastLast