MY zte blade L5 just keeps looping on the telstra initialising screen. When the power button is held down the phone does a short vibrate, this is normal, then i release the power button and the telstra logo appears. After a short while the screen goes blank, the phone does the short vibration again and the telstra logo appears again. this iteration goes on until the battery is flat.
I have also held the power button and volume down buttons down simultaneously and the screen shows
select boot mode:
volume up to select volume down is ok
recovery mode
fastboot mode
normal mode
however after selection the phone just goes into the reiteration of the start up logo sequence loop as stated above.
Can the phone be fixed ?