- 09-07-2006, 09:44 AM #1
I just got my Razr V3 and I notice that the charger connection fits very tightly into the Razr. To remove the connector after charging, I must pull very strongly. I'm afraid that this will eventually cause the tiny pins inside the Razr to break eventually. On my older Motorola, the charger has a "Release" button that you press to easily remove the charger connector from the phone. Why was that discontinued?
› See More: Problem Charging the Motorola Razr V3
- 09-09-2006, 12:20 AM #2
Re: Problem Charging the Motorola Razr V3
If you question is "Why was it discontinued?" Simple. The charger design was flawed, these chargers (and this can be backed up by just recent posts) seemed to not hold up very well under ANY kind of abuse no matter how minute and would just stop working or just occasionally work and in general were not very cost effective. As far as your charger being hard to pull out, unless your an infant, something wrong the port should have a very slight wiggle and pull out easily, make sure that your charger is a moto (with the engraved M on it) and that there isn't any bends or objects in the port or the charger itself. Something isn't right if it's difficult to remove.
Last edited by Griffzan; 09-09-2006 at 12:25 AM.
Similar Threads
- Motorola RAZR
- Motorola RAZR
The Ukrainian Review
in Chit Chat